Information for Visiting Demonstrators




Our club rooms are at Hemlington Hall Barn, Hemlington, Middlesbrough.
The postal address is:-Hemlington Hall Barn, Nuneaton Drive, Hemlington, Middlesbrough TS8 9DA.
Note that your satnav will take you into Nuneaton Drive and tell you that you are there. Continue for about 200 metres to the end of this road into the car park and we are in the barn up the concrete steps.



Someone will be there by about 5.15pm to open up.


If you get lost or need to make contact en route please ring Brian on 07899 043535.
We meet every Wednesday, from 6.30 p.m. until 9.00 p.m.
Click on "Diary of Events" below for details of specific events.

LATHE DETAILS.
The lathe which we usually put out for demonstrators is a Silverdrive direct drive lathe with electronic speed control and a 33m x 3.5mm headstock thread and 2MT tailstock drive.
It is fitted with a Charnwood Nexus chuck with 50mm jaws. We can provide a set of large jaws (100mm) if required and this chuck will also take jaws from Supernova, G3 Nova, Patriot, Record SC3 and Record SC4.



Silverdrive Lathe.


If preferred we can supply any of the following lathes.
1. Record CL2 with electronic speed control 3/4" x 16tpi and 1MT.
2. Axminster Trade Series AT1416VS midi size, electronic speed control 33mm x 3.5mm and 2MT.
3. Axminster M900 - manual speed control, 1" x 8tpi and 2MT.

DIRECTIONS. See webpage entitled "Where to find us"



Home Page
About Us
Diary Of Events
Newsletters
Competitions
Where to Find Us
Members' Work Gallery
Contact Us
Useful Links